Hello,
when exeuting a teststep then the duration is displayed after each teststep and also in the log.
But why does it show different values?
And why is the resolution only in seconds? In the logfile in the first line there is a another value in ms.
I would prefer to see the teststep duration also in ms.
Thx
For the ms vs s this scales dynamically based on how long the actual test takes (you’ll notice at the bottom or your screen there is a us timestamp).
For the mismatch, what value are you using in the Time Delay setting? I wasn’t able to reproduce this, but it does seem similar to another issue we have had reported.
